PowerView - Hunter Douglas - Gen3 hub


PowerView - Hunter Douglas - gen3 hub

This driver works with the PowerView Hub Generation 3, allowing to control Hunter Douglas shades with PowerView Motorization.

Connecting

To connect to the PowerView Hub, simply set the IP of the hub, the driver should automatically connect when apply is pressed. Choose the Polling time and the Refresh polling time. The first one corresponds to the time between state updates from the hub, the second one is the time between asking the hub to refresh the state. If the hub is not refreshed, the position of the shades will not be updated quickly when changed without the hub (e.g., manual, remote control). A small number will keep the resources correctly updated on the BLI but it may drain the battery faster and cause a constant blinking of LEDs in shades and repeaters. Please choose a value greater or equal than the polling time, if you don’t want to refresh insert -1.

Adding resources

Adding a resource can be done by introducing the shade Id as an address or, preferably by pressing the Import resources button and then Load resources from the connected system. Shades of type Bottom Up/Top Down or DuoLite will be discovered in separate resources, For example, Bottom Up/Top Down will discover 2 separate resources, one for the top rail and one for the bottom one. In the case of the Duolite shades, the resources discovered will be the shade, the blackout, and the tilt if the resource is the DuoLite with Tilt. The address of these related resources will be :X, all of them should be added to have full control of the shade.

Supported resources

Supported Resources are: - BOTTOM UP: Bottom-up shade with the commands to raise, lower, stop and set shade level. - BOTTOM UP WITH TILT: Bottom-up shade with tilt with the commands to raise, lower, stop and set shade level, as well as raise tilt, lower tilt, stop tilt and set tilt level. - TOP DOWN: Top down shade with the commands to raise, lower, stop and set shade level. - VERTICAL: Vertical shade with the commands to raise, lower, stop and set shade level. - VERTICAL WITH TILT: Vertical shade with tilt with the commands to raise, lower, stop and set shade level, as well as raise tilt, lower tilt, stop tilt and set tilt level. - STANDARD SHADE AS TILT ONLY: Tilt only shade, controls and appearance in the BeoLiving App are the same as a regular shade. Available commands are to raise, lower, stop and set shade (tilt) level. - BOTTOM UP/TOP DOWN - TOP: Top (middle) rail of Bottom Up/Top Down shades with the commands to raise, lower, stop and set rail level. - BOTTOM UP/TOP DOWN - BOTTOM: Bottom rail of Bottom Up/Top Down shades with the commands to raise, lower, stop and set rail level. - DUOLITE SHADE: Shade of Duolite or Duolite with tilt shades with the commands to raise, lower, stop and set shade level. - DUOLITE BLACKOUT: Blackout of Duolite or Duolite with tilt shades with the commands to raise, lower, stop and set blackout level. - DUOLITE TILT: Tilt of Duolite with tilt shades, controls and appearance in the BeoLiving App are the same as a regular shade. Available commands are to raise, lower, stop and set shade (tilt) level. - SCENE: Defined scene with command PRESS to activate it.

DISCLAIMER: Only Bottom Up and Bottom Up/Top Down shades were tested, let us know any problems with the untested resources to the email address below.

Changelog

v0.3

  • First version with support for gen3 hub

Please, report any issue with this driver to: support+drivers@khimo.com